Surge Rudder Rear Assembly Blade- Trailing Flip Up (No Foot section) Fusion

This Surge Rudder Rear Assembly is a flip down rudder (Spring loaded for the up position) designed for Sea, Touring and Sit On Top kayaks. This set comprises the back half of the rudder but not the foot controls.
The rear assembly includes
-Rudder blade
-Rudder mount (Rudder mount pin is 6cm long and has a hole at the bottom for a securing with a split ring as per a rear mount rudder bracket (not included) as well the pin as t as a cut out for use in a top mount bayonet pin housing.
-Rudder lowering cord, toggle ball, Jam Cleat and 2 x deck eye suitable for recessed deck mounts (may be used proud but will stick up). Pulling on the toggle ball uses the cord to lower the rudder blade into the water for use and the deck cleat holds cord (and therefore the blade) in place in place. The deck mounts are used to route/direct the cord on the deck of the kayak allowing it to be out of the way for hatches etc. Releasing the cord from the cleat allows the rudder spring to flip the blade out of the water into it’s retracted position for paddling without a rudder (e.g. in Surf or shallow water) or for transport and storage.
-Cord suitable for rudder controls and short tube
This is thin cord to attach the rudder to foot controls to allow directional control. 4 short lengths (10cm) of plastic tube are provided to minimise water ingress into your kayak and allow the cord to run freely without wear on your kayaks deck. These go through holes in the deck. Commonly manufacturers may us a tube going the full length of the cord to fully isolate the rudder control lines from the inside of your kayak. Should you choose to do this it is available separately.